![]() load_helper This command has no output and returns you immediately to the switch: prompt.There will be some scrolling text as the switch tells you what it's doing, but it should end at the switch: prompt. flash_init The flash_init command initializes the flash. ![]() The switch should now be at a switch: prompt. For reference, I've included the table from the Cisco documentation as Table 1 below. How long you have to hold down the Mode button depends on the model of Catalyst you're using. Power off the switch, hold down the Mode button, and power the switch back on.I'll assume that you already have the a serial cable connected to the device and you're staring at a Password: prompt. Below, I'm going to give you a quick run-down of what you need to know out of that document. The Catalyst password recovery procedure starts off by reseting the Catalyst to it's original factory settings. If you've ever needed to reset a Cisco Catalyst switch to it's factory default (locked out, perhaps?), you've probably spent some time digging around on Cisco's web site.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |